The wonderful thing about wrought iron is that it’s heavy — when used as the stuff for a storm door, it provides a sense of safety against intruders and … storms. Painting the door a dark color can strengthen that solidity, while painting it light can give it an inviting sense that functions better at a friendly area. Either way, you’ll find spraying wrought iron simpler and neater than brushing it, but both will get the job done.
Selecting a Color
Since you can see the most important door behind the wrought iron storm door, then it’s important to contemplate how the colours of the 2 doors blend. Black, white and gray are neutral — if dull — choices that work with most other colours, but no one said wrought iron needs to be boring. You may try thinking about that the storm door as part of the general door display, and choose a color that complements, contrasts or harmonizes with the door color. Dramatic combinations are apt to attract lively visitors; should you would rather keep your house peaceful, then utilize harmonious colors that convey a soothing message.
Take the Door Down
Wrought iron doors are heavy, and you may need help to take yours down, but that’s actually the perfect way to paint it. You’ll be able to wash all the steel more extensively and apply primer and paint in difficult-to-reach areas. Remove the screen, if there’s one attached, by unscrewing it in the frame — it’s usually better to leave the screen unpainted. Lay the door out on a set of sawhorses. If it’s a brass doorknob and hinges or other components you don’t need to paint, cover them with painter’s tape.
Preparing the Metal for Painting
In any wrought iron structure, rust can develop in the areas where water moves, which is normally close to the junction of a vertical tine and a railing. Remove as much of the rust as you can by sanding or scrubbing with steel wool or a wire brush, then treat it with a rust-inhibiting item. Use a paint scraper or the wire brush to remove any peeling or flaking paint, scuff all old paint using 150-grit sandpaper to etch it. Before you perform any of this, you’ll probably need to wash the whole door using a hose to remove dirt. If the door is either oily or oily, wash it as opposed to a solution of trisodium phosphate and water.
Applying Primer and Paint
All rusty areas and areas with bare metal has to be secured with a coat of metal primerthat is readily available in aerosol cans. Utilize exterior metal paint for the topcoat; you’ll get the best results from an aerosol can, however if you can’t locate the color you need at a can, use a brushable item. After brushing, always stroke back toward the paint you have already implemented, then stroke over each section gently after all the paint was implemented to erase brush marks. Apply two coats to each side. Allow the paint dry for 24 hours, hang the door and perform final touch-ups.